User Tools

Site Tools


flashlight_kit_build_instructions

This is an old revision of the document!


Snowman Kit Build Instructions

http://lowvoltagelabs.com/products/flashligh-kit/

Step 1 - Check that all the parts were included with the kit Check that all the parts were included with the kit

Step 2 - Install the battery holder with the opening to the left Install the battery holder into the PCB

Step 3 - Install push button S1 into the PCB Install the switch S1 into the PCB

Step 4 - Fold the leads of the resistor over before installing into the PCB Bend the resistor before installing into the PCB

Step 5 - Install resistor R1. Fold the leads over on the back. Install the resistor into the PCB

Step 7 - LED and right angle LED holder LED and LED holder

Step 100 - Flip over the PCB and solder the parts Back side of the flashlight PCB once the parts are installed and ready to solder

Step 101 - Install a 2032 battery with the positive side up Step 9 - Install a 2032 battery with the positive side up

Step 10 - Turn on the switch and watch the LEDs flash Flashlight kit finished

flashlight_kit_build_instructions.1414243608.txt.gz · Last modified: 2014/10/25 06:26 by eric