This is an old revision of the document!
Flashlight Kit Build Instructions
Step 1 - Check that all the parts were included with the kit
Step 2 - Install the battery holder with the opening to the left
Step 3 - Install push button S1 into the PCB
Step 4 - Fold the leads of the resistor over before installing into the PCB
Step 5 - Install resistor R1. Fold the leads over on the back.
Step 6 - Assemble the LED and right angle LED holder together, before installing into the PCB.
Step 7 - Insert the LED into the LED holder so that the longer lead matches up with the long lead hole on the PCB when installed.
Step 8 - Bend the leads of the LED at a 90 degree angle before installing into the PCB
Step 9 - Install the LED holder with LED into the PCB
Step 10 - Turn over the flashlight and solder the parts on the back
Step 11 - All parts are now soldered and installed
Step 12 - Install a 2032 battery with the positive side up. Press the push button to turn on the flashlight.
flashlight_kit_build_instructions.1414245976.txt.gz · Last modified: 2014/10/25 07:06 by eric