====== Pumpkin Kit Build Instructions ====== [[http://lowvoltagelabs.com/products/pumpkin-kit/]] **Step 1** - Check that all the parts were included with the kit Step 1 - Check that all the parts were included with the kit **Step 2** - Find the resistor Step 2 - find the resistor **Step 3** - install the resistor into location R1 Step 3 - install the resistor into location R1 **Step 4** - find the switch Step 4 - find the switch **Step 5** - Install the switch into location S1 Step 5 - install the switch into location S1 **Step 6** - Find the battery holder Step 6 - find the battery holder **Step 7** - Install the battery holder into location BT1 Step 7 - install battery holder into location BT1 **Step 8** - Find the 10mm LED Step 8 - find the 10mm LED **Step 9** - Install LED into location D1 with the longer lead of the LED into the square (+) pad Step 9 - install LED into location D1 with the longer lead of the LED into the square pad **Step 10** - Turn over the printed circuit. Bend the leads of the parts to hold them in place. Step 10 - turn over the printed circuit. Bend the leads of the parts to hold them in place. **Step 11** - Solder the parts to the board Step 11 - solder the parts to the board **Step 12** - Install a 2032 battery with the + side up. Turn on the switch and watch the LED flicker! Install a 2032 battery with the + side up. Turn on the switch and watch the LED flicker!