User Tools

Site Tools


pumpkin_kit_build_instructions

Pumpkin Kit Build Instructions

http://lowvoltagelabs.com/products/pumpkin-kit/

Step 1 - Check that all the parts were included with the kit

Step 1 - Check that all the parts were included with the kit

Step 2 - Find the resistor

Step 2 - find the resistor

Step 3 - install the resistor into location R1

Step 3 - install the resistor into location R1

Step 4 - find the switch

Step 4 - find the switch

Step 5 - Install the switch into location S1

Step 5 - install the switch into location S1

Step 6 - Find the battery holder

Step 6 - find the battery holder

Step 7 - Install the battery holder into location BT1

Step 7 - install battery holder into location BT1

Step 8 - Find the 10mm LED

Step 8 - find the 10mm LED

Step 9 - Install LED into location D1 with the longer lead of the LED into the square (+) pad

Step 9 - install LED into location D1 with the longer lead of the LED into the square pad

Step 10 - Turn over the printed circuit. Bend the leads of the parts to hold them in place.

Step 10 - turn over the printed circuit. Bend the leads of the parts to hold them in place.

Step 11 - Solder the parts to the board

Step 11 - solder the parts to the board

Step 12 - Install a 2032 battery with the + side up. Turn on the switch and watch the LED flicker!

Install a 2032 battery with the + side up. Turn on the switch and watch the LED flicker!

pumpkin_kit_build_instructions.txt · Last modified: 2013/10/22 20:17 by eric